Fujitsu Ten ECLIPSE OWNER'S MANUAL / CD3200
Press the [SELECT] (Up/Down) button to select PEQ.
Press the [ENTER] button.
The PEQ setting mode is activated.
Press a button from [2] to [6] while the PEQ setting mode is activated.
Pressing the button allows you to toggle through preset EQ modes as follows:
Button | Mode | Patterns |
---|---|---|
[2] | DEFEAT | No EQ adjustments |
[3] | POWER | The pattern that emphasize the bass range. |
[4] | SHARP | The pattern that emphasize the treble range. |
[5] | VOCAL | The pattern that emphasize the middle range. |
[6] | CUSTOM | Custom pattern |
Frequency level and Q curve for 3 bands (BASS, MIDDLE and TREBLE) can be adjusted separately. Q curve pattern can be chosen from Narrow, Normal, MidWide or Wide for BASS, Narrow or Normal for MIDDLE, and Normal for TREBLE.
Press the [ENTER] button to select the band to be adjusted.
Each time the button is pressed, the band changes in the following order.
BASS →MIDDLE →TREBLE →···
Press the [SELECT] (Up/Down) button to adjust the Q curve pattern.
Each time the button is pressed, the Q curve pattern changes in the following order.
When BASS is selected:
WIDE ↔ MidWIDE ↔ NORMAL ↔ NARROW ↔ WIDE ↔···
When MIDDLE is selected:
NORMAL ↔ NARROW ↔ NORMAL ↔···
When TREBLE is selected:
NORMAL (Fixed)
Press the [SELECT] (Right/Left) button to adjust the frequency.
Each time the button is pressed, the frequency changes in the following order.
When BASS is selected:
60Hz ↔ 80Hz ↔ 100Hz ↔ 120Hz ↔ 60Hz ↔···
When MIDDLE is selected:
700Hz (fixed)
When TREBLE is selected:
7.5kHz ↔ 10kHz ↔ 12.5kHz ↔ 15kHz ↔ 7.5kHz ↔···
The median frequency and the Q curve you set are used for BASS, MIDDLE and TREBLE in the audio control mode. (For details, .)
When the median frequency and the Q curve are adjusted, CUSTOM EQ is also updated.