Print this page

Others

Connecting a portable audio player to the AUX jack

Use a commonly available accessory cable with an RCA connector or an optional AUX105 to connect a portable audio player to the AUX (auxiliary) jack of this system.

There are 2 connection terminals on this main unit; one for the RCA connector and the other for the optional LAN cable (AUX 105). The default setting for AUX is OFF.

1Turn on the portable audio player and start its play function.

The AUX mode is activated.

For details, Switching Audio Modes.

attention
  • While the AUX mode is activated, actions such as turning off the audio player or pulling out the connection cord may cause noise spikes that can damage the system speakers. Be sure to avoid this possibility by turning off system power or switching from the AUX mode to another mode before shutting off or disconnecting the portable audio player.

  • Audio output levels for the various devices that can be connected using this method will differ. Carefully adjust the volume until the output level of the connected player is known.

  • Before using a portable audio player in a vehicle, read the player's operation manual carefully and confirm problem-free operation in the vehicle before proceeding.

  • When you connect an optional LAN cable (AUX 105) to the main unit, other optional equipment that uses E-LAN cannot be connected.

Switching the AUX mode on and off

1Press the [/MENU] button for more than one second.

The Menu selection mode is activated.

2Press the [SELECT] (Up/Down) button to select FUNC, and then press the [ENTER] button.

The function mode is activated.

3Press the [SELECT] (Up/Down) button to select AUX ON/OFF.

The AUX ON/OFF mode is activated.

4Press the [SELECT] (Up/Down) button to select the ON/OFF mode.

Press the button to switch the mode as follows:

Up:
Mode is ON

Down:
Mode is OFF

The selected settings will take effect.

Switching the input system

When using an optional AUX cord (AUX105), the main unit can be switched between RCA input and optional AUX cord (AUX105) input.

1Press the [MODE] button for more than one second.

The system will switch between RCA input and optional AUX cord input each time the button is pressed.

RCA input (INPUT) ↔ Optional AUX cord (SUB INPUT)

Changing auxiliary input sensitivity

The sensitivity of the auxiliary mode can be changed.

1Press the [/MENU] button for more than one second.

The Menu selection mode is activated.

2Press the [SELECT] (Up/Down) button to select FUNC, and then press the [ENTER] button.

The function mode is activated.

3Press the [SELECT] (Up/Down) button to select AUX Sens.

The AUX sensitivity mode is activated.

4Press the [SELECT] (Up/Down) button to select the sensitivity mode.

Pressing the button allows you to toggle through sensitivity modes as follows:

Low ↔ Mid ↔ Hi ↔ Low ↔···

The selected settings will take effect.