Displaying a Simulation of the Route

You can run a simulation of the route currently being navigated. Follow the steps below to use the initial settings screen.

1. If the Map screen is displayed, touch to return to the navigation menu.

1. Touch on the navigation menu.

1. Touch .

1. Scroll down through the list, and then touch . The simulation begins from the start point and works through the entire route at the recommended speed.

1. (Optional) You can use the following buttons during the simulation (although the control buttons disappear after a few seconds, you can touch the map to show them again).

• : Returns to the previous route event (the previous change in the route)

• : Pauses the simulation.

• : Goes to the next route event (the next change in the route)

• : Changes the speed of the simulation. You can select from speeds of x4, x8, or x16. Touch again to return to normal speed.

1. Touch to stop the simulation.