Print this page

Sound Adjustment Mode

Crossover adjustment (X-Over)

Specified frequency bands are allocated to each speaker for improved sound integration.

1Select "Cross Over" by pressing the [] or [] button.

2Press the [ENTER] button.

The crossover setting mode is activated.

3Press the [ENTER] button to set the crossover adjustment channel.

Each time the button is pressed, the channel changes in the following order.

Front → Rear → Woofer → Front → ···

4Select the cut-off frequency by pressing the [] or [] button.

Each time the button is pressed, the frequency changes in the following order.

Front/Rear:

63 Hz ↔ 80 Hz ↔ 100 Hz ↔ 125 Hz ↔ 160 Hz ↔ 200 Hz ↔ 250 Hz ↔ 315 Hz ↔ 400 Hz ↔ 500 Hz ↔ 630 Hz ↔ 800 Hz ↔ 1 kHz ↔ 1.25 kHz ↔ 1.6 kHz ↔ 2 kHz ↔ 2.5 kHz ↔ 3.15 kHz ↔ 4 kHz ↔ 5 kHz ↔ 6.3 kHz ↔ 8 kHz ↔ 10 kHz

Woofer:

20 Hz ↔ 25 Hz ↔ 31.5 Hz ↔ 40 Hz ↔ 50 Hz ↔ 63 Hz ↔ 80 Hz ↔ 100 Hz ↔ 125 Hz ↔ 160 Hz ↔ 200 Hz

5Specify the slope by pressing the [] or [] button.

The slope can be set to "Pass", "6 dB/oct", "12 dB/oct", "18 dB/oct" or "24 dB/oct".

[]:
The slope becomes more gentle.

[]:
The slope becomes steeper.

6Repeat the steps 3 to 5 to change the settings for each channel.