Table Of Contents

- About Sound Adjustment Mode
- Switching the sound adjustment mode
- Parametric equalizer adjustment (PEQ)
- Selecting an equalizer mode from memory
- Resetting the Equalizer mode
- Automatically adjusting the equalizer mode (Auto EQ)
- Changing the equalizer mode (Auto EQ) based on the measurement result
- Time alignment adjustment (Time Alignment)
- Position selector
- Crossover adjustment (X-Over)
- Multi-harmonizer settings (Harmonizer)
- Non-fader settings (Non-F Setting)

TOP >
Sound Adjustment Mode >
Position selector

Sound Adjustment Mode

Position selector

You can adjust the sound field to the listener seat position.

Select "Position Selector" by pressing the [] or [] button.

Press the [ENTER] button.

This changes to the Position Selector setting mode.

Select the desired position by pressing the [], [], [], or [] button.

Pressing each button changes the position as follows.

If the same button is re-pressed, the position is reset.

[]:
FRONT

[]:
REAR

[]:
FRONT-RIGHT

[]:
FRONT-LEFT

attention

FADER or BALANCE cannot be specified together with Position selector.
Time Alignment cannot be specified together with Position selector.