Adjusting the guide lines

You can adjust the Back Eye Camera guide lines as needed.

• Be sure to turn the ignition switch off when getting off the vehicle to apply markings.

• Stop the vehicle in a safe location before adjusting the guide lines.

• Before displaying the guide lines, make sure to align them with your vehicle.

• When an optional back eye camera is connected, the guide lines are set to either the normal mode. To use a mode that has not set guide lines, cancel the display of guide lines.

1. Apply two line markings with packing tape, etc. on the ground at a distance of approximately 20 cm (0.656 ft) from each side of the vehicle.

1. Move the vehicle approximately 2.5 m (8.2 ft) straight ahead, and then apply a line marking on the ground so that it is under the rearmost position of the vehicle.

1. Apply markings (four positions) on the ground at distances of 50 cm (1.64 ft) and 2 m (6.56 ft) from each end of the line marking that is applied as the rearmost position of the vehicle.

1. Touch .

• If the Navigation screen is displayed, change to the Multi screen or Audio operations screen before performing this operation.

• If is not displayed, touch .

1. Touch .

• If Camera switch is not displayed, touch to change the page.

1. Adjust the guide lines.

• :

• Touch to change the point being adjusted.

• , , , :

• Touch each switch to adjust the selected point.

• :

• Touch to return the point to its original position.

• :

• Touch to return to the previous screen.

1. Touch .