Loading/Unloading a Disc

When you listen to a music, insert a CD into the drive slot. Also, when you play a movie, insert its DVD into the slot.

Loading Steps

• You may not be able to open or close the display when the gearshift lever is set to P in an automatic transmission car; 1/3/5 or R in a manual transmission car; or a bottle or a similar object is placed in the cup holder. To open or close the display safely, set the gearshift lever to N (automatic transmission car) or to the Neutral position (manual transmission car) in advance, or empty the cup holder. Make sure that the car is not in motion by applying the parking brake and appropriately stepping on the foot brake in order to prevent damage or injury.

• Do not place a cup or can on the display while the display is opened. Doing so may damage the display.

• Do not press the [ (OPEN/EJECT)] button while inserting a disc into the slot.

This receiver can play 8cm CDs and 8cm DVDs. To avoid disc problems, insert a disc without using an adapter.

1. Press the [ (OPEN/EJECT)] button.

• The display will open and the disc insertion slot will open.

1. Insert a disc into the slot.

• The display will close automatically when the disc is inserted.

• Hold a DVD or CD correctly (by inserting your finger in its center hole and by holding the disc edge by another finger), face the disc label side upward, and insert the disc into the slot.

• When you insert a DVD into slot, its movie will be played in the DVD mode.

• When you insert a CD into slot, its music will be played or the MP3/WMA play will start.

CD/DVD unloading steps

• When unloading a disc, use the following notes.

• Automatic transmission (AT) car:

• If it is difficult to unload disc when the shift lever is in P position, shift it to the N position. (If your car has a column shift lever, shift it to the P or N position.)

• Manual transmission (MT) car:

• If it is difficult to unload disc when the shift lever is in “1”, “3”, “5” or “” position, shift it to the Neutral position.

• Take care NOT to close the display when the ejected disc remains in the slot. If this caution is not observed, this receiver or the disc may be scratched.

• Do not push and close the display by hand, or the display will be damaged.

• Wipe and clean the display immediately if juice or another type of liquid spills onto it. If it is not cleaned, the display may be damaged.

• To protect the display from heat and dusts, keep the display closed except when you load or unload a disc.

• If the disc does not eject (for example, if it is jammed), hold down the [ (OPEN/EJECT)] button for more than 5 seconds.

1. Press the [ (OPEN/EJECT)] button.

• This opens the display and ejects the disc.

1. After the disc has been ejected, press the [ (OPEN/EJECT)] button.