Manual setting of steering wheel switch functions
You can manually assign the desired functions to every steering wheel switch buttons.
To do so, turn the power supply off and set it to the standby state. For details, see Turning the POWER ON or OFF.
Your manual setting may fail due to the ambient environments including the outdoor temperature.
When the power switch is off, hold down both [CTRL] and [TP/TEXT] buttons for 3 or more seconds.
Select “CSTM” using the [SELECT (Up)] or [SELECT (Down)] button.
Press the [BAND] button.
Hold down the [CTRL] button.
The state of a no signal is read.
Select a desired function using the [SELECT (Up)] or [SELECT (Down)] button.
A function is selected in the following sequence each time you press the button.
TRACK UP ↔ TRACK DOWN ↔ VOL UP ↔ VOL DOWN ↔ MODE ↔ MUTE ↔ PWR ↔ OTHERS ...
Press the [BAND] button.
Hold down the steering wheel switch button you wish to store in memory, and simultaneously press the [CTRL] button more than two seconds.
When the function is set correctly, “OK” is displayed.
Assign the desired functions to the steering wheel switch buttons by repeating Steps 5 through 7.
When you have set all functions, hold down the [BAND] button.
If “NG” is shown on the display, once again select a desired function to set.
