Fujitsu Ten ECLIPSE OWNER'S MANUAL / CD3200
Various audio control modes may be fine-tuned using this procedure.
Press the [ENTER] button for less than one second to select the item to be adjusted.
Modes will switch in the order shown below each time the button is pressed.
BASS → MID → TREB → BALANCE → FADER → NON-F*1→ LOUDNESS → SVC*2→ VOL → BASS···
*1 NON-F (non-fader) Output is not affected by the settings of the BASS, MID and TREB.
*2 Setting cannot be made in FM mode.
Mode | Function | Rotary Mode | |
---|---|---|---|
Left | Right | ||
BASS | Adjusts bass level. | Decrease level. | Increase level. |
MID (MIDDLE) | Adjusts middle level. | Decrease level. | Increase level. |
TREB (TREBLE) | Adjusts treble level. | Decrease level. | Increase level. |
SVC(Source Volume Control) | Adjusts different volume levels for each audio mode. | Decrease level. | Increase level. |
FADER | Adjusts the audio balance of the front and rear speakers | Emphasizes rear speakers. | Emphasizes front speakers. |
BALANCE | Adjusts the audio balance of the right and left speakers | Emphasizes the left speakers. | Emphasizes the right speakers. |
NON-F (NON-FADER LEVEL) | Adjusts non-fader level (for subwoofer). | Decrease the sub-woofer level. | Increase the sub-woofer level. |
LOUDNESS | The loudness control may be turned on to emphasize low and high frequencies at low volume levels. Loudness boosts bass and treble at low volumes. | Select OFF | Select ON |
The volume for the default FM mode (default value: 40) is used as a reference for storing the differences in volume that have been set for each audio mode.
Audio mode | FM | AM | CD | USB | BT-Audio |
---|---|---|---|---|---|
Default value(Volume level) | Reference(40) | 0(40) | 0(40) | 0(40) | 0(40) |
SVC setting(Volume level) | Reference(40) | SVC settingvalue-15 (55) | SVC setting value-10 (30) | SVC setting value+5 (45) | SVC settingvalue-5 (35) |
When volume level in FM mode is adjusted from 40 to 45 | 45 | 55→60 | 30→35 | 45→50 | 35→40 |
When volume level in CD mode is adjusted from 35 to 60 | 45→70 | 60→80* | 60 | 50→75 | 40→65 |
When volume level in AM mode is adjusted from 80 to 20 | 70→5 | 20 | 60→0* | 75→10 | 65→0 |
When volume level in USB mode is adjusted from 10 to 35 | 5→30 | 20→45 | 0→20 | 35 | 0→25 |
*1 The volume levels can only be set from 0 (min) to 80 (max). The volume difference can be set within a range of -10 to +20.