Print this page

Names of controls and parts

Turning the power on and off

When the power is turned on, the state used when the power was turned off such as CD and tuner playback is restored.

When the vehicle has no ACC position on the ignition switch, care is needed when turning off the main unit. Follow Step 2 or Step 3 when turning off the power.

1Press the [SOURCE/PWR] button while the power is OFF.

The power will come ON.

attention
  • When the main unit's power is turned on for the first time or if the battery terminals have been disconnected because of a reason such as vehicle maintenance and the power is then turned back on, the main unit will start up in FM1 mode. After this, the broadcast stations will be searched for automatically and stored in buttons [1] to [6].

2Press the [SOURCE/PWR] button while the power is ON, for more than one second, until you hear a beep.

The power will go OFF and the main unit will be in Standby.

If you press the [SOURCE/PWR] button again for more than two seconds, the power will go completely off.

3While the power is ON, press and hold the [SOURCE/PWR] button until the "ACC OFF" message is displayed.

The power will go completely OFF.

attention
  • If the vehicle does not have an ACC position, press the [SOURCE/PWR] button until the "ACC OFF" message is displayed.
  • Back
  • Next

>Page Top